Copper M-Press Fittings
Copper M-profile press fittings from 15mm to 54mm for heating and water: couplings, elbows, bends, tees, reducers, crossovers, threaded adaptors and lever ball valves. Joints are flame-free, made in seconds with an M-profile press tool. Fittings come in full manufacturer bags or boxes, never split. Order by 12pm for next working day UK delivery.
Copper M-press fittings from 15mm to 54mm
Copper M-profile press fittings make a permanent, watertight joint on copper tube in seconds, with no flame, flux or solder. This means:
- They're safer in occupied homes.
- No hot-works permit is needed on commercial sites.
- Joints can be made on wet pipe.
- Every joint is consistent.
The range.
- Equal and sleeve couplings, straight reducers and fitting reducers.
- Equal and unequal elbows, including elbows with an insert (i/a) end.
- 45° bends.
- Equal, unequal and female tees.
- Full and partial crossovers.
- Male and female threaded adaptors, tap connectors and wall-plated elbows.
- End caps.
- Lever ball valves, including versions with a female thread.
Sizes run from 15mm to 54mm, depending on the fitting.
Pressing. M-press fittings must be pressed with M-profile jaws. Our electric hydraulic press tool set and angled jaw sets cover the common sizes. Insert the tube fully to the depth mark, then press.
Full bags and boxes. Fittings are sold in full manufacturer bags or boxes, never split, so you get a known, sealed quantity every time.
Our press vs solder vs compression guide explains the time and cost savings.